How to use the camera
Setting up a Network Video Stream
1. The first thing you are going to want to do to get your camera up and streaming on your network is to connect your camera to power, an active network port on your network, and finally, power on the...
Connect your camera to the network
When you are first getting setup it is helpful to connect your camera to an HDMI monitor, but you can also use the SDI output to view video from your camera as well. Once your camera is powered on and...
How to set the resolution of the camera
The camera's resolution is set by a yellow dial on the back interface board of the camera. you can reference the available frame rates in your manual or on a table printed on the bottom of your camera. NOTE: the...
How to use OBS to connect to the RTSP video stream of the camera
The follow steps will be very similar in video production software such as vMix, Wirecast or xSplit. Open OBS and add a Scene. In the scene we can add a source with the plus button in the area right next...
What resolutions do the Prisual cameras output?
The Prisual camera line has 16 different selectable resolutions. These are changeable using the rotary dial on the back of the camera.Please note: each time you make a change to the rotary dial, be sure to power cycle your camera...
How to quickly build a live broadcast system
If you want to build a live broadcast system, Prisual is undoubtedly the best choice. We provide you with professional high-performance, low-cost audio and video equipment and control equipment. First of all, you need to choose a solution based on the...
How to use WAN to control IP cameras(DDNS)
1 Setup IP Controlled by Dynamic DNS Two dynamic DNS: Dyndns.org, 3322.org. Router Port Mapping: Take Tenda router for example, enter the Router Home Page (interface page), select “Advanced”- “Virtual Server”, add a new port number in “Ext Port”, add a...
Prisual Cameras Maintenance and Troubleshooting
Camera Maintenance If the camera will not be used for a long time, please turn off the power switch. Use a soft cloth or lotion-free tissue to clean the camera body. Use a soft dry lint-free cloth to clean the...
Key Description 1. Standby Key Press this button to enter standby mode. Press it again to enter normal mode.Note: Power consumption in standby mode is approximately half of the normal mode 2. Number Key To set preset or call preset....